Electronics Engineer

Що робити

Designing schematics and PCB layouts for robot subsystems, docking stations, and production tooling;
Circuit design of individual blocks: microcontroller support circuitry, sensor signal chains, interfaces (SPI, I²C, UART, CAN, USB, Ethernet), power and switching circuits, application of standard BLDC motor and pump drivers;
Preparing boards for production (DFM, Gerber, BOM), working with contract manufacturers, sourcing components and alternates;
Prototyping: soldering and assembling samples, board bring-up with test firmware written in C for STM32, taking measurements and reworking the design based on test results;
Assembly and electrical installation of robots and docking stations: boards, drives, sensors, cable harnesses, commissioning against a checklist;

Higher technical education (electronics, radio engineering, automation, instrumentation, or similar);
Confident analog and digital circuit design: understanding how a circuit actually works, not just how to draw one from an app note;
Experience developing multilayer boards (power and ground planes, signal routing, thermal behavior) and deep knowledge of Altium Designer, KiCad, or equivalents;
Power circuits and drives: switching converters, LiFePO4 packs, protection circuits, current sensing, BLDC motors with standard drivers, encoders;
C programming for STM32 at the board bring-up level, and confident use of Git;

Experience in robotics, mobile platforms, or battery-powered portable devices;
Experience in servicing or providing technical support for complex equipment;
Work with CAN, RS-485, and other industrial interfaces;
Experience designing assemblies that operate in wet environments or under vibration.

Знайдено через trackr.help/jobs · Канал: @trackrhelp · Бот для персональних сповіщень: @trackrhelpBot