PCB Engineer (Sensor Systems)

Що робити

Sensor system hardware (primary focus)
Design, develop, and test hardware for sensor systems built around microcontrollers (MCU + sensors) and single-board computers (SBC + sensors).
Translate system requirements into modular and scalable schematics, PCB layouts, and Bill-of-Material (BoM) selection.
Design mixed-signal PCBs interfacing to a broad range of sensors, including analog front-ends and digital buses (I2C, SPI, UART, 1-Wire, CAN, RS-485).
Specify signal-conditioning and data-acquisition chains: amplification, filtering, ADC/DAC selection, voltage references, and noise management.

3+ years of professional hardware/PCB design experience: schematic capture and multi-layer PCB layout for mixed-signal systems.
Hands-on experience designing MCU-based and SBC-based hardware and interfacing it to sensors over analog and digital interfaces.
Experience integrating low-power RF/wireless links (up to 5 GHz, up to ~10 W): RF-aware layout, controlled impedance (50 Ω), matching networks, and antenna integration.
Strong grasp of mixed-signal PCB layout: minimizing noise coupling, grounding strategy, power distribution, and EMC/EMI mitigation.
Experience bringing up and debugging prototype hardware with standard lab equipment (oscilloscope, multimeter, spectrum analyzer, VNA, etc.).

Opportunity to work in an office in Khmelnitsky or ability to work remotely (only in Ukraine);
Competitive remuneration;
Constant professional growth and development;
Provision of equipment as needed;
A dynamic and supportive work environment, with access to cutting-edge tools and resources;

Знайдено через trackr.help/jobs · Канал: @trackrhelp · Бот для персональних сповіщень: @trackrhelpBot